Pressure-injection for cracks in structural concrete, masonry, wood, etc.

Gravity-feed of cracks in horizontal concrete and masonry.

Epoxy resin binder for epoxy mortar patching and overlay of interior, horizontal surfaces.

Seal interior slabs and exterior above-grade slabs for water, chlorides, mild chemical attack and to improve performance.

Grouting bolts, dowels, pins, etc.

Industrial Floorings

Walkways

Waterproof Decking

Secondary Containment Lining with or without Geo Textile

Encapsulation of Concrete Vaults, Fiberglass & Polystyrene Foam

Coating of Safety Posts

Mold Castings

Boat Linings

Truck Bed Liners

Cargo Liners

Utility Vehicles

Horse Trailers

Viscosity @ 80°F (27°C), Brookfield:
Side A                                                               500 +/- 50 cps
Side B                                                               900 +/- 50 cps                            
Mix Ratio (by volume)                                                       1:1
Pot Life                                                             10-14 seconds
Tack Free (@150 mils. thickness)               40-60 seconds
Recoat Time                                                            6-12 hours
Density (Side A & B combined)                          9.45 lbs/gal
Flash Point                                                                     >200°F
Elongation, ASTM D-412                                     175 +/- 50%
Tensile, ASTM D-412                                  3,000 +/- 300 psi
Hardness, ASTM D-2240                             60-62 Shore D
Tear, ASTM D-624                                                 450-475 pli
Service Temperature                                      -20°F to 200°F

Mixing:

HT AR-SPRAY 55 may not be diluted under any circumstances.  Thoroughly mix side B material with a jiffy mixer until a homogenous mixture and color is obtained.  Do not allow air to be incorporated into the product.  Side A Isocyanate requires no mixing. 

Application:

Precondition both the A and B sides to between 75-80° before application.   HT-AR-SPRAY 55 should be applied using a plural component, low pressure spray mixing machine like the Hi-Tech SB2005.