Email  
 
 
Frequent Ask Questions  

Questions:
  How much material do I need for a repair?
  How fast does the polyurea joint fill cure?
  What colors are available and can you match colors?
  What about mixing and warming the polyurea joint fill?
  Can I coat over the polyurea joint fill with other products?
  What is the reason the polyurea joint fill did not cure?
  How much polyurea joint fill do I need to fill a floor joint?
  What else can be done with polyurea?
  How long does it take to get a pump once I order it?
  What grade of dry silica sand can I use?
  Can I use this material to repair exterior concrete?
  Why did the product swell while it was curing?
  What products can I dispense with this pump?
  Can you modify your pump to fit my needs?
  Why did the material not set up in the joint?
  How much sand should I mix with the Spall material?

Question: Can you modify your pump to fit my needs?
 
Answer:
We manufacture the pumps at our facility in Rancho Cucamonga, California. The pump comes standard to run off an extension cord. Optional battery/inverter set ups are available, along with larger tanks, heat belts, low pressure spray rigging, low viscosity set ups, custom frame colors, modified gear ratios for material that is not 1:1 ratio, etc…
 
Home    About     Contact    Sitemap