|
|
| External Joint Sealer |
|
Our trusted quality Flexible Control Joint Sealer, is now ready for the outdoors. If you need some joints or controled cracks to be filled look no further than our own Hi-Tech PE 60.
Basic Info:
HT-PE60 is designed specifically for filling exterior control joints, new construction joints, and exterior random cracks on horizontal concrete surfaces to help protect from pneumatic-tired vehicles and prevent penetration of water and incompressibles into the joints. Highly flexible, allowing normal joint and slab movement as designed, yet strong enough to protect the vertical edges of concrete from spalling under extreme loading. Exposure to ultraviolet light will cause discoloration, however the physical properties are unaffected. It is recommended to broadcast sand over the material while curing to help minimize discoloration.
The HT-PE60 is a technologically advanced, self leveling, 100% solids, two component, 1:1 ratio, Polyurea Elastomer exterior joint filler. Designed for exterior concrete with medium to high thermal cycling. HT-PE60 cures rapidly and consistently in applications ranging from -20ºF to 130ºF. Product is tack free in 5 to 10 minutes. Applications can be reopened to traffic in 1 hour.
Some Practical uses:
- Freeways
- Airport Runways
- Taxiways
- Refueling & Maintenance Areas
- Bridge Decks
- Elevated Parking Structures
- Sidewalks
Advantages:
- 100% Solids, Meets VOC Regulations.
- Flexible, 750-950% Elongation
- Return Project to Service in 60 Minutes
- Cures From -20ºF to 130ºF
- Odorless, No Toxic Vapors
- Resistant to Petrochemicals & Jet Fuels
- Remains Flexible, Even in Cold Temperatures
Physical Properties:
| Color | A+B | Clear |
| Viscosity (mixed) | Self Leveling |
| Mix Ratio (by volume) | 1:1 |
| Pot Life | 100 grms at 77F | 1-2 min |
| Tack Free (thin film) @ 77F | 5 min |
| Initial Cure | 30 min |
| Final Cure | 3 hours |
| % of Elongation | ASTM D-412 | 420 min |
| Tensile Strength, psi | ASTM D-412 | 740 min |
| Shore “A” Hardness | ASTM D-2240 | 60-62 A |
| Tear Strength, pli, Die C | ASTM D-624 | 160 min |
Contact us for more information.
|
|
 |
|
|
|
|
_03.gif)
