Email  
 
 
HT-PE95  
The HT-PE95 is a technologically advanced, self leveling, 100% solids, two component, 1:1 ratio, Polyurea Elastomer joint and crack filler. Designed for concrete with low to medium thermal cycling. HT-PE95 cures rapidly and consistently in applications ranging from -20ºF to 130ºF. Product is tack free in 5 to 15 minutes. Applications can be reopened to vehicle or foot traffic in 1 hour.



Download Product PDF

 

HT-PE95 is designed specifically for industrial floor applications, which receive heavy vehicle traffic, such as forklifts or steel wheeled carts. To fill interior random cracks, damaged control joints, or new control joints on horizontal concrete. Highly flexible, allowing small slab movement, yet strong enough to protect the vertical edges of concrete from spalling under extreme loading. Interior and Exterior (exterior applications when little joint or crack movement from thermal cycling will occur.) Exposure to ultraviolet light may cause discoloration, however the physical properties are unaffected.

    • Industrial Facilities
    • Warehouse Floors
    • Manufacturing Facilities
    • Pulp and Paper Mills                
    • Bottling and Canning Facilities              
    • Airports
    • Water and Waste Water Treatment
    • Cold Storage Facilities
    • Food Processing Facilities
    • Freezers

  • 100% Solids, Meets VOC Regulations.
  • Meets USDA & FDA Requirements
  • Cures in Damp Conditions
  • Not Affected by Moisture
  • Flexible, 460-500% Elongation
  • Return Project to Service in 60 Minutes
  • Cures From -20ºF to 130ºF
  • Odorless, No Toxic Vapors
  • Resistant to Petrochemicals
  • Remains Flexible, Even in Cold Temperatures

    • Color                      A+B                                    Concrete Gray
    Viscosity (mixed)                                                  Self Leveling
    Mix Ratio (by volume)                                                         1:1
    Pot Life  100 grms at 77°F                                           1-2 min
    Tack Free (thin film) @ 77°F                                      5-10 min
    Initial Cure                                                                     60 min
    Final Cure                                                                      2 days
    % of Elongation                   ASTM D-412                   460 min
    Tensile Strength, psi             ASTM D-412                1,600 min
    Shore “A” Hardness           ASTM D-2240                  90-93 A
    Tear Strength, pli, Die C       ASTM D-624                   375 min

    22 oz. Cartridges 56 oz. Cartridges 10 gal. Units


     
    Home    About     Contact    Sitemap