Spall TX Flex  

Spall TX FLEX is a rapid set, high strength ultra low viscosity Polyurea repair material. This two part, 1:1 system is 94% solids and designed for rebuilding and repairing broken control joints and spalled concrete surfaces very quickly. HT Spall-FLEX is intended for use in damaged control joints or warehouse spalls where there is slight movement and damage is from steel wheels or small hard urethane wheels.
Download Product PDF
 Launch Crack Repair video
Launch Gallon Kit video

  • Rebuilding control joints
  • Shallow spalls on bridge decks
  • Traffic area spalls & crack repairs
  • Grade matching
  • Floor repair
  • Stops additional damage
  • Fill & repair spall before coating
  • Used to “knit” cracked slabs
    		•
  • Meets USDA and FDA Requirements
  • Cures from  -20° F to 130° F.
  • “Drive-Over” in 10 to 15 minutes
  • Produces High Strength Quickly
  • Slightly Flexible
  • Self-leveling
  • Self Priming
  • Fast initial set; rapid gain to ultimate strengths.
    		•
    Viscosity (Mixed)                                        
    Hardness, durometer (ASTM D2240)                 
    Tensile Strength, PSI (ASTM D412) -            
    Tear Strength (ASTM D624)                 
    Elongation % (ASTM D412) -                 
    Compressive Strength (neat)                   
                                         (with sand)   
    Bond Strength ASTM 882-99                                		 250 cps
    60A
    3700
    -lb/mil 460
    7% to 9%
    3400 psi
    4500 psi
    3450
    22 oz. & 56 oz. Cartridges 1 Gallon Kit (with proportioning chambers) 2 Gallon, 5 Gallon, 10 Gallon Kits

    		 
    Untitled Document
     Spall Repair
     Road Repair
     Pumps
     Epoxy Products
     Polyurea
     Other Products
     Product Chart


    Member Login

             User   
      Password   
      
     
     
    Website Design by Optious