HT Spall-TX2  

HT Spall-TX3 is a rapid set, high strength low viscosity Polyurea repair material. This two part, 1:1 system is 94% solids and designed for rebuilding and repairing broken control joints and spalled concrete surfaces very quickly, as well as filling voids. HT Spall-TX3 is intended for use in damaged control joints, voids under concrete or tile, and warehouse spalls where there is no movement and damage is from steel wheels or small hard urethane wheels. HT Spall-TX3 has an extended pot life for larger jobs requiring more time.
Download Product PDF Launch Crack Repair video
Launch Gallon Kit video

 

  • Rebuilding control joints
  • Shallow spalls on bridge decks
  • Traffic area spalls & crack repairs
  • Grade matching
  • Floor repair
  • Stops additional damage
  • Fill & repair spall before coating
  • Used to “knit” cracked slabs
  • Fill voids under concrete or tile

  • Meets USDA and FDA Requirements
  • Cures from  -20°F to 130° F.
  • “Drive-Over” in 45 minutes
  • Produces High Strength Quickly
  • Self-leveling
  • Self Priming
  • Fast initial set; rapid gain to ultimate strengths.

    • Viscosity (Mixed)                                            250 cps
    Hardness, durometer (ASTM D2240)          67 to 72D
    Tensile Strength, PSI (ASTM D412)                   4600
    Tear Strength (ASTM D624)                      -lb/mil 489
    Elongation % (ASTM D412)                        6% to 8%
    Compressive Strength (neat)                          3900 psi
    (ASTM C109)            (with sand)                 4800 psi
    Bond Strength (ASTM 882-99)                          3450

    22 oz. & 56 oz. Cartridges 1 Gallon Kit (with proportioning chambers) 2 Gallon, 5 Gallon, 10 Gallon Kits


    		 
    Untitled Document
     Spall Repair
     Road Repair
     Pumps
     Epoxy Products
     Polyurea
     Other Products
     Product Chart


    Member Login

             User   
      Password   
      
     
     
    Website Design by Optious